Philips Colour Television Service Manual page 92

EN 92 9. DPTV585 AA
9.3.21 Line Output
Horizontal drive from the HOP panel is fed to 7807 on the Large
Signal panel. Transistor 7807 drives the Horizontal Output
Transistor 7801, which drives the Yokes and the Horizontal
Output Transformer 5801. Transformer 5801 produces plus
and minus 13-Volt supplies for the Vertical Output circuit. It also
produces a 200-Volt source and Filament voltage for the CRT
panels. The output of 7807 also drives 7803 and 7802, which
drives the Dynamic Focus circuit.
9.3.22 Frame Amplifier
Figure 9-29 Frame circuit
The Vertical drive from the HOP panel drives the Vertical
Output IC 7811. This IC is located on the Large Signal panel.
Drive is fed to pin 7 and is output on pin 5 to drive the three
Vertical Yokes. This IC is powered by the plus and minus 13-
Volt supplies from the Horizontal Output circuit. A Vertical pulse
on pin 6 is fed to the sweep failure detection circuit. If there is
a failure in the Horizontal or Vertical sweep, the High Voltage
will be shut down.
Circuit Descriptions, List of Abbreviations, and IC Data Sheets
Figure 9-28 Line output circuit
E_15000_096.eps
181004
E_15000_095.eps
181004