8
Quick-release axle in
threaded bush (wheel
carrier)
122
37 lb/ft (50 Nm)
Tighten the right-hand axle
clamping screw 2 with the
specified torque.
Clamping screw for
quick-release axle to
wheel carrier
14 lb/ft (19 Nm)
z
Remove front wheel stand.
Insert ABS sensor into hole
and install screw 1.
Slide the brake calipers onto
the brake rotors.
Install securing screws 3 on left
and right with specified torque.
Front brake caliper on
wheel carrier
22 lb/ft (30 Nm)
Clip on retaining clip 1 holding
the sensor cable to the brake
line.
Secure new cable tie 2.
Remove adhesive tape from
wheel rim.
Press handbrake lever firmly
a number of times until resis-
tance point is noticeable.