Using The Microphone/Guitar; Using The Timer - JVC RV-NB20B Instructions Manual

Using the microphone/guitar

Microphone/guitar mixing
Using a microphone or a guitar (not supplied), you can mix its
sound with a source sound.
1. Make sure the MIC/GUITAR LEVEL control
on the rear of the system is properly set.
• When using a microphone, make sure the knob is pressed in
( ).
• When using a guitar, make sure the knob is released (
2. Set the MIC/GUITAR LEVEL control to MIN
by turning it fully counterclockwise.

Using the timer

The timers let you control the listening functions automatically.
Setting the clock
When the power is first supplied, the CLOCK indicator and "0:00"
flash on the display. Set the clock.
Note:
The clock must be correctly set for the timers to work.
Using the remote control only
1. Press ON/STANDBY.
2. Press CLOCK/TIMER repeatedly until the
CLOCK indicator lights up.
The hour digit flashes on the display.
3. Press x or 4 to select the hour.
• When you press and hold the button, the hour digit changes
continuously.
4. Press SET to set the hour.
The minutes digits start flashing on the display.
5. Press x or 4 to select the minute.
• When you press and hold the button, the minute digit changes
continuously.
• If you want to change the hour setting, press CANCEL.
6. Press SET to finish setting the clock.
15
3. Connect a microphone or a guitar into the
MIC/GUITAR INPUT jack on the rear of the
system.
4. Start a source: disc, tuner, iPod, or
auxiliary equipment.
5. Adjust the VOLUME +/– control and the
MIC/GUITAR LEVEL control, as you play the
microphone or the guitar.
).
CAUTION:
DO NOT connect a bass guitar to the MIC/
GUITAR INPUT jack, as it may damage the
system.
ON/STANDBY
CANCEL
SET
SLEEP
CLOCK/TIMER
4 x
CAUTION:
If memory backup batteries are exhausted or not
installed, and the AC power cord is plugged in
again after being disconnected, or power is
restored after a power failure, the CLOCK
indicator will flash on the display. Set the
current time (clock) again.
Setting the sleep timer
Use the sleep timer to turn the system off after a certain number of
minutes when it is playing. By setting the sleep timer, you can fall
asleep to the music and know that your system will turn off by
itself rather than playing all night.
You can set the sleep timer only when the system is turned on.
Using the remote control only
1. Press SLEEP.
The SLEEP indicator lights up on the display.
SLEEP indicator