Table of Contents
Advertisement
TT420
Appendix D
The printout of the status shows the current settings of the TT420. Before activating the
status printout, insert ribbon and material of at least 80 mm width as described in chapters 4
and 5.
The test printout contains the following information.
PROGRAM VERSION: VX.XX
TONE ADJUST: +XX
FEED ADJUST: +XX.Xmm
CUT POSITION ADJUST: +XX.Xmm
BACKFEED ADJUST: +XX.Xmm
PARAMETER: [PC-850][0]
[9600][8][1][NONE][0]
[ON][AUTO][FEED][B0]
X-COORDINTE ADJUST: +XX.Xmm
SENSOR: TRANSMISSIVE [17]
MEMORY: [192KB][XXXKB]
TTF AREA: [XXXKB][XXXKB]
EXT CHAR AREA: [XXXKB][XXXKB]
BASIC AREA: [XXXKB][XXXKB]
PC SAVE AREA: [XXXKB][XXXKB]
INFORMATION: XXXXXXXXXXXXXX
TOTAL FEED: X.XXKm
The most important information on the status printout is the chosen sensor mode and its
sensitivity.
Operating instructions
Status printout
XXXX
Firmware version and check sum
Print tone fine adjustment value
Print position fine adjustment value
Cut position fine adjustment value
Back feed amount fine adjustment value
Character code selection and font "0" selection
Baud rate, data length, stop bit length, parity, und
transmission control
Forward feed wait function, Control code, Feed key
Function, and Euro code
X-coordinate fine adjustment value
Sensor selection and sensitivity
memory capacity of the main PC board and optimal
memory card (0,1,2,3,4,6,8)
true type font storage area, main PC board and
optional memory card
Writable character storage area, main PC board and
optional memory card
BASIC file storage area, main PC board and optional
memory card
PC save storage area, main PC board and optional
memory card
Printed only if some information is stored in the flash
ROM
Total feed distance
42
Advertisement
Table of Contents
