First Wash Cycle; Precautions And General Recommendations - Whirlpool AWT 4103 Instructions For Use Manual

FIRST WASH CYCLE

We recommend that the first wash cycle be carried out empty. This will remove any residual water used
in the factory checks.
1.Turn on the tap.
2.Close the drum flaps.
3.Pour a small amount of detergent (about 30 ml) into the detergent dispenser
4.Select a short programme and low spin speed (see programme chart).
5.Switch on the appliance.

PRECAUTIONS AND GENERAL RECOMMENDATIONS

1.Packing
• The packaging materials are 100% recyclable and
bear the recycling symbol
regulations when disposing of packaging material.
2.Energy saving tips
• Achieve the best use of energy, water, detergent
and time by using the recommended maximum
load size.
• Do not exceed the detergent dosages indicated
in the manufacturer's instructions.
• The Eco Ball - a special system in the outlet - will
prevent detergent loss from the drum to avoid
detergent loss into the environment.
• Use "Prewash" for heavily soiled laundry only!
Save detergent, time, water and energy
consumption by not selecting "Prewash" for
slight to normally soiled laundry.
• Pretreat stains with stain remover or soak dried
in stains in water before washing to reduce the
necessity of a hot wash program.
• Save energy by using a 60° C instead of a 90° C
wash programme or a 40° C instead of a 60° C
wash programme.
• Save energy and time by selecting a high spin
speed to reduce the water content in laundry
before using a tumble dryer (for machines with
adjustable spin speed).
3.Disposing of packaging and old appliances
• The washing machine is built from reusable
. Adhere to local
• Before scrapping old machine, cut of the power cable
• Remove detergent from compartment if you
4.Child safety
• Children must not be allowed to play with or in
5.General recommendations
• Do not leave the appliance connected when not
• Before cleaning or carrying out maintenance
• To clean the outside of the washing machine,
• Do not use abrasive detergents.
• Do not attempt to force the lid open.
• If necessary, the power cable may be replaced
6.EC Declaration of Conformity
• This washing machine has been designed,
materials. The washing machine must be
disposed of in compliance with current local
waste disposal regulations.
so that the washing machine cannot be connected to
the mains.
intend scrapping your appliance.
the appliance.
in use. Turn off the tap.
switch off the washing machine and disconnect
it from the mains supply.
use a neutral detergent and a damp cloth.
with an identical one obtained from our After-
Sales Service. The power cable must only be
replaced by a qualified technician.
constructed and distributed in compliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
.
19