JVC KD-G411 Service Manual page 8

QQ
3.1.4 Removing the side panel 3 7 63 1515 0
(See Fig.4)
• Prior to performing the following procedure, remove the front
panel assembly as required.
(1) Remove the screw B and two screws C attaching the side
panel on the left side of the main body, and take out the
side panel.
3.1.5 Removing the rear bracket
(See Fig.5)
• Prior to performing the following procedure, remove the bottom
cover.
(1) Remove the three screws D, screws E and two screws F at-
taching the rear bracket on the back side of the main body.
(2) Take out the rear bracket.
Reference:
Insert the STEERING cable into the slot before attaching the
rear bracket to the main body.
TE
L 13942296513
3.1.6 Removing the main board
(See Fig.6)
• Prior to performing the following procedures, remove the front
panel assembly, bottom cover, front chassis assembly, side
panel and rear bracket.
(1) Remove the two screws G attaching the main board.
(2) Disconnect the connector
the main body and take out the main board.
www
.
1-8 (No.MA135)
http://www.xiaoyu163.com
CN501 on the main board from
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
B
C
Side panel
Insert STEERING cable into the slot.
D
E F
Q Q
3 6 7 1 3 1 5
CN501
G
co
.
9 4 2 8
C
Fig.4
Rear bracket
D
E
0 5 8 2 9 9 4 2 8
Fig.5
Main board
Fig.6
m
9 9
D
9 9
G