Program Mode Playback; Basic Mode; Playing Program Steps In Random Order - JVC XL-MC222BK Instructions Manual

PROGRAM MODE PLAYBACK

Discs and tracks can be selectively specified in a program and played
according to the program in the PROGRAM mode.
The steps in the program can be played in a random order
(RANDOM function).
The entire program can be played repeatedly (REPEAT function)
or one program step can be selected and played repeatedly
(REPEAT-1 function) in the basic mode as well as when the
RANDOM function is selected.

Basic mode

1. Select the mode.
Use the PLAY MODE button, or press the PROGRAM button
on the remote control, showing "PROGRAM" on the display.
PLAY MODE
2. Specify disc or track numbers in the order you want to play in
the following manner:
(a) Specify a disc number and a track number.
Press the DISC or TRACK button and then use the DISC/
TRACK jog dial. The – or + buttons as well as the numeric
buttons can also be used.
DISC
The track number can be omitted when programming a
whole disc to be played.
Press the CANCEL button to cancel the specified disc and
track numbers shown on the display.
(b) Press the MEMORY button to register the specification as
program step 1.
MEMORY
Up to 32 steps can be entered in one program. Each disc,
when the whole disc is to be played, or each track
programmed is counted as one step.
(c) Repeat Steps (a) and (b) above to program the remaining
steps.
10
PROGRAM
or
(Remote control)
TRACK
or
(Remote control)
MEMORY
or
(Remote control)
Reviewing the steps:
Press the CALL button. One step is displayed each time the button
is pressed.
Deleting a step:
Press the CALL button and display the necessary step. Then press
the CANCEL button.
Adding a step:
An added step is placed in the last step automatically.
Deleting all steps:
Press the STOP/CLEAR button. The entire program will be cleared.
3. Press the PLAY/PAUSE button or the
according to the program.
The program reviewing and modification procedures described
above can also be performed when the playback is stopped.
The program will be retained and available whenever the
PROGRAM mode is selected again as long as the unit is kept in
the standby state.
If the AC power cord is disconnected from the outlet, the program
will be erased.
Playing program steps in random
order
To play every step in the program once in random order, press the
RANDOM button, showing "RANDOM" on the display. Then start
playing.
The playback will be stopped when all program steps have been
played.
If the disc specified in the program is not in the disc storage, the
playback stops. The playback starts again after you load the disc
and press the PLAY/PAUSE button or the
control.
Press the RANDOM button again to cancel the function, clearing
the indication from the display during stop.
button to start playing
button on the remote