T O N E P A R T - TYT TH-UVF 9 User Manual

Picture 5 and Picture 6,
1 1 ^
Picture 6: 2tone as receiving decoder
Group 0:.2 tone decoder
Group 1: single tone decoder
Picture 5: 2tone as transmitting encoder
Group 0:2 tone
Group 1: single tone
A s single tone calling, only input A T o n e (e.g. A T o n e is 1750 Hz), no need to input
in another T o n e . T h e T o n e in "Group Call" should be t h e s a m e to the T o n e of
e n c o d e r ( 9 0 0 . 3 M H z ) .
Step 3: Set the optional signal of the desired channel to be 2-Tone. Click "More" after every
f r e q u e n c y y o u edit, program it in t h e p o p u p . (Picture 7/8)
" ! ' il._S!!I_l
J4n 80000
l-niaoooo
r
[411.80000
™ l ™
|4n.80000
.... J
Of.
P—3
d • •
P
3
Picture 7: Select group 0 as 2-Tone Picture 8: Select group 1 as single-tone
Make 2-tone call with the t r a n s c e i v e r
1) P o w e r o n , then select the channel with 2-Tone signal
2) Press [ ] key, L C D displays " C A L L / 2 T ? " ,
then press [ G B I ] key to transmit 2-Tone while press [ EES] to
transmit a single t o n e / G r o u p call. If the corresponding call list
has not been edited, it will s o u n d " D U " .
-CALL
:2T ?
5 - T o n e P a r t
Edit 5tone m e s s a g e
Click in s e q u e n c e " p r o g r a m - O p t i o n a l F e a t u r e s - O p t i o n a l S i g n a l - 5 - T o n e " to p r o g r a m
5-Tone ID and 5-Tone international standard group.
T h e group n u m b e r s 0-9 in t h e call list is used to edit the 5tone ID of the radio y o u w a n t to
call. Y o u c a n put 0-9, A , B, C, D and n u m b e r (including repeated ID)
T h e group in t h e international standard are: C C I R 1 , C C I R 2 , C C I T T , EEA, EIA, N A T E L ,
Z V E L 1 , Z V E L 2 , 9 g r o u p s in total.
Select o n e of t h e m a n d input self ID (input in ID), a n d then write into t h e radio.
155