TYT TH-UVF 9 User Manual page 27

2) Press [ Sffl ] + [ E B I ] [ ^ ] or press [ B ] + [ E B ] , then press
[ B ] to enter
3) Press [ C S ] to c h o o s e C T C S S m o d e , L C D displays C - C D C 67.0
4) Press [ B S ] or [ O ] to c h o o s e 1 5 4 . 1 , t h e n press [ B ] to confirm
5) Press [ I S D ] twice to exit
6) Press [ B ] + [ ^ 3 0 ] , the digit blinl<s at the right top of L C D
7) Press [ a ] or [ K S I ] to c h o o s e or input 05 directly
8) Press [ I B S ] for storage, L C D displays M R m o d e and currently
stored channel
C h a n n e l delete
1) Under M R or C H m o d e , press [ B S D ] to turn on the radio, L C D
displays " D E L ? " a n d channel n u m b e r blinks at the right top of
L C D .
2) Press [ E 9 ] or [ K a ] or input channel n u m b e r y o u w a n t to
delete, then press [ B ] to confirm
3) After delete, it will skip into next channel, if y o u w a n t to delete it,
repeat above operation.
441
7 ) F M R A D I O F U N C T I O N
1) On/off radio receiver
U n d e r standby m o d e , press [ S B ] to o p e n FM radio function, L C D
display "76.00M", then press [ G B ] a g a i n , radios receiver is off.
Note: under FM radio mode, if receiving the signal, the radio will be out
of FM mode, after 5 8 , it will be back to FM mode when the signals
disappear.
2) M o d e selection:
Under FM radio m o d e , press [ BSD ] to switch b e t w e e n FM m e m o r y
m o d e and F M f r e q u e n c y m o d e (this function is unavailable w h e n
there is not F M m e m o r y channel)
3) Frequency selecting
Under FM f r e q u e n c y m o d a e , input the digits directly by k e y p a d or
press [ c a ] or [ E i ] to c h o o s e the desired frequency. Under F M
m e m o r y m o d e , press [ffSS ] or [ S 3 ] to c h o o s e the desired c h a n n e l .
4) F M radio s e a r c h :
Under FM radio m o d e , press [ B ] + [
], then press [ B
]
again to enter F M radio s c a n n i n g , y o u will see " R A D I O S E E K . U P "
in the s c r e e n , press [ E a ] or [ K a ] to c h a n g e scanning direction.
Radio will stop scanning w h e n frequency is available and then exits.
If y o u rotate the e n c o d e r knob, it will scan a g a i n ; press a n y key