McIntosh MX151 Owner's Manual page 57

500Hz. In such a case the MX151 would set
the crossover point for both the Low and High
Frequency Outputs to 125Hz.
2. When using both AUX1/2 (Balanced Outputs)
and AUX3/4 (Unbalanced Outputs) at the
same time, it is important to make sure the
settings (AUX perform, AUX cutoff and AUX
order) are set the same. This assures match-
ing of the crossover curves Low Pass and
High Pass, as there is only one set of Front
Left and Front Right Channel Outputs. Refer
to figure 6.
3. When the Electronic Crossover or Multiple
Sub-woofer Mode of operation is active, the
signal normally present at the Subwoofer Out-
put is now available at the AUX Outputs only.
Speaker Configuration
L XL
C M
R XL
RS M
RBS M
LBS M
LS M
SUB Sub 80
AUX1/2 (L/R) Custom
AUX3/4 (L/R) -
Edit/Select
Verify Current Setup
Back
Figure 3
Select Perf.
-
XXL
XL
L
M
S
XS
Custom
Back
‡
Select Perf.
-
Sub 80
Sub 100
Sub 125
Sub 160
Sub 200
Sub 400
Sub 800
Custom
Back
ˆ
Auxiliary Output and Elecrtonic Crossover, con't
‡
ˆ
Figure 4
‡
ˆ
Figure 5
AUX1/AUX2 (L/R)
AUX perform Custom
AUX cutoff 250Hz
AUX order 4th LiRi
Gain offset 0.0dB
Back
Figure 6
Verify Configuration
Output : L
Volume : -44.0dB
High-pass 80Hz
Continue
Abort
Figure 7
Verify Configuration
Successfully verified
Speaker Configuration
Ok
Figure 8
‡
ˆ
‡
ˆ
‡
ˆ
57