McIntosh MX151 Owner's Manual page 44

Creating a Backup
The MX151 includes the capability of backing up any
changes made to the factory default settings. With a
backup made, to an external USB Drive (not supplied),
it makes restoring those settings easier in the event
reseting the MX151 becomes necessary. To create a
backup perform the following steps:
Note: RoomPerfect Measurements and Corrections
are not saved.
1. Press the SETUP Push-button on the Remote Con-
trol. Refer to figure 86.
Note: The MX151 Front Panel Push-buttons may be
used instead of the Remote Control.
2. Using the q(Down) Push-button scroll down thru
the Installer Menu to "Device Management" and
then press the SELECT Push-button. Refer to
figure 87.
3. With "New Backup" highlighted press the SE-
LECT Push-button. Refer to figure 88.
4. Change the "Backup To" option from "STOR-
AGE" to "USB" by using the  (Right) Push-but-
ton and Downq Push-button. Refer to figure 89.
5. Insert into the MX151 Rear Panel USB Socket a
Formated USB Drive (PC Format) with at least 1G
bytes of available memory.
6. Referring to figure 89, with "Create Backup"
highlighted, press the SELECT Push-button. Refer
to figure 90.
7. Using the ▲ (Up) Push-button highlight "Yes" and
press the SELECT Push-button. Refer to figure 91.
Then press the SELECT Push-button.
8. Use the SETUP Push-button to exit from the
Setup Mode.
9. Remove the USB Drive from the MX151 Rear
Panel and keep it in a safe place.
44
Installer Menu
Speaker and Room Setup
Source Setup
Audio Processing Setup
Zone B Setup
System Setup
Device Management
Exit
Figure 86
Device Management
Backup and Restore
Software Info
Software Update
Factory Defaults
Back
Figure 87
Backup and Restore
New Backup
Restore Backup
Delete Backup
Back
Figure 88
‡ Create Backup
Backup To
Backup Name:
"bkup001"
Create Backup
Back
ˆ
Confirm Create Backup
‡
Create backup:
"bkup001"?
Yes
No
ˆ
‡ Backup Created
Press enter to continue
ˆ
‡
USB
ˆ
Figure 89
‡
ˆ
Figure 90
‡
ˆ
Figure 91