Front Panel description
Rear Panel description
OPERATION
Power Up
Test Dish
Find Satellite
Memory Card
Firmware Upgrade
Network Configuration
Log Files
Error Messages
Error Codes defined
Programming Network Configurations
Performing a TEST DISH
MotoSAT Technical Support Information
COMPONENT AND FUNCTIONAL DEFINITIONS
Mount – FREEDOM Dome and dish mechanics
FREEDOM SD2 – aka. Positioner, Controller or Control Box
SD Card – The memory card used to load programming code and configuration
LNB – The device under the dome that receives the satellite signal
Control Cable – The 9 conductor cable that connects the Mount to the FREEDOM SD2
SD Card – The data storage device which provides software and configuration updates
Azimuth Motor – The motor on the mount that controls azimuth movement
Elevation Motor – The motor on the mount that controls elevation movement
Scotch Locks – The devices used to splice electrical wires on the mount
LED – The lights on the front panel of the FREEDOM SD2 that indicate system status
Software – Code which instructs the mount to locate and identify satellites
Configuration File – The code that tells the mount which satellites to identify
Log Files - Diagnostic files for monitoring the system as it goes through its various routines
800-247-7486 – The number that you may call if you have any questions concerning your
FREEDOM or its operation
INDEX
3
4
5
6
7
7
8
8
8
9
10
10
11