Table of Contents
Advertisement
3. Camera Installation
Use the appropriate brackets and equipment to mount this camera.
After installing the camera, your network camera should be accessed
from your local network. Configure network routers first.
Package Contents:
Camera x1 Rubber Pad x1
Insulation caps x3 Guide Pattern Sticker x1
Self-tapping screws x3 Plastic anchor x3
RJ 45 female coupler x 1 Document CD x1
Printed Quick Start Guide x1
3.1 Installation
This section details how to set up the camera.
3.1.1 Drill the Mounting Location
1. Place the "guide pattern sticker" on the desired mounting
location.
2. Drill the marked holes
3.1.2 Positioning the Camera
Listed below are different ways to adjust the camera position to
capture the desired field of vision.
1. Loosen the screw (a.) to rotate either the camera or "pipe
segment". Select the desired position then tighten the screw to
set the position.
2. Loosen the screws on both sides (b.) to change the mounting
bracket angle. Move the camera into the desired position.
Tighten the screws to set the position.
INSTALLATION
9
Advertisement
Table of Contents
