Reset Camera - i3 Ax41B1MVR Instruction Manual

• Trigger an Alarm When Ethernet is Lost: set an alarm condition
when Ethernet disconnected.
• Digital Input: send a signal to the camera to trigger an alarm. Check
it to enable this function. Then, set digital input as "High" or "Low"
• Motion Detection: this function is designed to record video once the
camera detects a motion condition. Select "Disable" to disable this
function or "Enable" to enable this function.
• Sensibility: set sensibility level as "Lowest", "Low", "Medium",
"High" or "Highest". Or input a value from 0 to 99 in the customized
threshold field. Higher number gets higher sensitivity.
• Press "Save" to save your settings.
• Action: Configure image transfer settings after triggering an alarm.
- Digital Output: select "OFF" to disable this function or "ON"
to enable this function. If select "ON", choose an output file's
resolution as "Low" or "High".
- Digital Output - If you want to set digital output function start, you
need to set ON. After that, you need to set "Active Type" (Low or
High) about digital output by the hardware.
• Alarm duration - The alarm time period of digital output.

6. Reset Camera

There are two ways to restore to Factory Default settings for the
camera. (The 1
6.2 Hardware Reset
If the Internet Explorer browser cannot be access for whatever
reason or Software Reset does not work then use Hardware Reset.
1. Loosen the two screws on top of the sunshield and remove the
sunshield.
INSTALLATION
is mentioned earlier in sec. 5.3.5.)
st
Please note this is for future use.
29