Using The Sonicwall Setup Wizard; Configuring The Sonicwall Tz 150 - SonicWALL TZ 150 Getting Started Manual

5

Using the SonicWALL Setup Wizard

The SonicWALL Setup Wizard provides user-guided instructions for
configuring your SonicWALL TZ 150.
Note: Make sure you have any required ISP information to complete
the configuration before using the Setup Wizard. See the list of
required information in Step 1, "Collect Required Information" on
page 2.
Tip: If you do not know what type of Internet connection you have,
contact your ISP. In addition, the SonicWALL Setup Wizard will
attempt to detect your connection settings. You will see what is
automatically selected in Step 3, WAN Network Mode

Configuring the SonicWALL TZ 150

Welcome - Click Next to begin.
1. Change Password - Change the administrative password. This
is the password for the admin account. Click Next.
Alert: Remember your password. You need it to access the
SonicWALL TZ 150 management interface after the initial
configuration.
2. Change Time Zone - Change the Time Zone setting to your
local time zone. Click Next.
Note: It is important that you set the time zone correctly before
you register your SonicWALL TZ 150.
3. WAN Network Mode - The Setup Wizard automatically detects
most networking modes. If it does not detect the networking
mode, you may have a Static IP Address. See Step 1, "Collect
Required Information" on page 2.
Confirm the selection or select the correct type of network
connection for your ISP.
• DHCP is commonly used with cable modems.
• PPPoE is commonly used with DSL modems.
Click on the yellow link for a networking type to see a definition.
Click Next.
SonicWALL TZ 150 Getting Started Guide Page 7