Inserting The Batteries Into The Remote Control; Connect Power & Antenna; Switching On/Off; First Time Installation - celcus LED40189FHDCNTD Operating Instruction

Inserting the Batteries into the Remote Control

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match
the + and - ends of the batteries in the battery
compartment (observe the correct polarity).
3. Replace the cover.
Connect Power & Antenna
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow the
TV set to reach the ambient room temperature before
you connect the set to the mains. Plug the aerial cable
into the ANT socket on your TV.

Switching On/Off

To Switch the TV On
Connect the power cord to the 220-240V AC, 50
Hz.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button
on the remote control or press the control switch
located on the left side of the TV.
To Switch the TV Off
Press the " " button on the remote control or
press and hold the control switch on the TV until
the TV shuts down. The TV will now switch to
standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active. The LED can also blink when you switch on
the TV from standby mode.

First Time Installation

selection" menu appears. The message "Welcome
please select your language!" is displayed and all
language options are listed alphabetically.
Press the " " or " " button to highlight the required
language, press OK button to select. "First Time
Installation" appears. Use " " or " " button to set
the required country, and press " " button to select
Search Type. Use " " or " " to set the desired search
type. Available search types are digital and analog,
digital only and analog only. When set, press " " to
select Teletext Language. Use " " or " " button to set
the "Teletext Language" and select "Scan Encrypted"
using " " or " " button. You can set Scan Encrypted
as Yes if you want to scan coded stations.
Default PIN code can change depending on the
selected country.
If you are asked to enter a PIN code for viewing a
menu option, use one of the following codes: 4725,
0000 or 1234.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
English - 7 -