Table of Contents
Advertisement
38
EN
Message
COM port is not
available.
Connected device
not found.
Error — Transfer
halted.
Appears when:
Action:
Not connected to COM port set by JLIP Initialize.
Check the COM port number and connector and
retry JLIP initialization.
Connected devices are not turned on.
Selected COM port is not connected properly.
Make sure connection is proper and carry out JLIP
initialization. Then turn on this unit and the
connected devices.
Video unit is brought to STOP or ends playback
during automatic capture.
Check the auto capture setting.
Full image data (768 x 552 pixels) cannot be
captured if you start auto capture at the beginning
of the tape. Video capture stops if video playback
is stopped.
Start video capture 20 seconds after the start of the
recording.
Tape is too short to match the preset number of
images or there is a section of non-recorded tape.
Click "OK", check the tape length and re-enter the
number of images to be captured. Use a fully
recorded tape.
LIST OF ERROR MESSAGES
Page
18
18,19
—
28
Advertisement
Table of Contents
Troubleshooting
