Midea MFA-96CRN1 Technical Manual page 154

R410A 50Hz Tropical Split AC MCAC-UTSM-2012-12
⑥ LOCK Button: Push this button to lock in all the current settings. To release settings, push again.
⑦ CANCEL Button: Push this button to cancel the TIMER settings.
⑧ TIMER Button: This button is used to preset the time ON (start to operate) and the time OFF (turn off the
operation).
⑨ ON/OFF Button: Push this button to start the unit operation. Push the button again to stop the unit
operation.
⑩ FAN SPEED Button: This button is used for setting Fan Speed in the sequence that goes from AUTO、
LOW 、MED to HIGH, then back to Auto.
TEMP Button: Push the button to increase the indoor temperature setting or to adjust the TIMER in a
clockwise direction.
VENT Button: Push this button to set the ventilating mode. The ventilating mode will operate in the
following sequence:
Note: ventilation function is available for the fresh air series.
1.3 Names and Functions of indicators on Remote Controller
Fig-2
①TRANSMISSION Indicator: This indicator lights when remote controller transmits signals to indoor unit.
② MODE Display: Show the current operation modes-- AUTO, COOL, DRY and HEAT. HEAT is only
available for heat pump model.
③ HEAT PUMP ONLY - LOCK display is displayed by pushing the LOCK button. Push the LOCK button
again to clear display.
④ TIMER Display: This display area shows the settings of TIMER.
That is, if only the starting time of operation is set, it will display the TIMER ON. If only the turning off time of
operation is set, it will display the TIMER OFF. If both operations are set, it will show TIMER ON OFF which
indicates you have chosen to set both the starting time and off time.
⑤ FAN Display: When push the FAN button, this indicator lights.
⑥ Digital Display Area: This area will show the temperature and, if in the TIMER mode, will show the ON
and OFF settings of the TIMER.
154