Omega OMB-PER-488/W95 User Manual page 35

Step 3: Verifying the GP488B Interface Installation & Driver488 Software Settings
1. To confirm proper installation, open the Control Panel window from the Start > Settings menu,
click on the System icon, and select the Device Manager tab. Look for a device type named
"IEEE488.2 Controllers" and below it, verify the presence of the new hardware device.
2. During Driver488 installation, a new Control Panel applet titled "IEEE 488" was installed under the
Control Panel with default settings selected.
To verify or configure the Driver488 software settings for your IEEE 488 interface(s) and IEEE 488
external device(s), see chapter Driver488/W95 & Driver488/WNT on page 41.
•
•
3. Restart Windows and once again verify the hardware installation and Driver488 configuration in
Device Manager.
At this point, the hardware and driver verification is complete. Continue to Step 4.
Step 4: Installing the GP488B Interface Software Support Files
1. Insert the disk titled "IEEE 488 Software Installation Disk, 1 of 2" into the floppy disk drive.
2. To install, you can do one of the following:
•
•
•
3. The Installation program will step you through various options on installing these software support
files.
Note:
4. Any or all of the installed software support files may be removed by going to the Control Panel
from the Start > Settings menu, double-clicking on the Add/Remove Programs icon, then selecting
"Personal IEEE 488 v 2.0", and clicking the Add/Remove... button.
At this point, the installation of software support files is complete.
Personal488 User's Manual For Windows 95 and Windows NT
When the I/O base address, IRQ (Interrupt), and DMA channel settings match the jumpered
board, select OK and restart Windows below.
If any of these settings do not match, manually reset each value. When all of the settings are
correct, select OK and restart Windows below.
Select Run from the Start Menu, type in
Go to My Computer or Windows Explorer, double-click on the Floppy Drive icon, then double-
click on the Setup icon.
Or go to the Control Panel from the Start > Settings menu, double-click on the Add/Remove
Programs icon, then click the Install button.
These files are NOT required to get the hardware to work properly, but it is recommended
if any software development is desired or Help files are needed.
, then click OK.
A:\SETUP.EXE
Personal488 (with GP488B) 29