Table of Contents
Advertisement
Carrier Status
Refer to Table 3.3: Unity 550 Types of OSD Action Fields on page 18 for updating specific
fields
Carrier Status is a read-only screen. (No changes can be made here.)
While on the Main Menu page:
1. Press the down arrow button until Carrier Status is highlighted.
2. Press ENTER.
3. You may review the details as shown in Figure 3.4 , below.
4. Press ENTER again to exit the Carrier Status screen.
Carrier Select
Refer to Table 3.3: Unity 550 Types of OSD Action Fields on page 18 for updating specific
fields.
While on the Main Menu screen,
1. Press the down arrow button until Carrier Select is highlighted
2. Press ENTER to enter the highlighted menu.
3. Navigate using the arrow buttons to place the cursor on the field you wish to edit.
4. Press the up arrow to increase the value or the down arrow to decrease the value of the
highlighted item.
5. Press ENTER to move to the next item or digit to be changed.
6. Repeat steps 3 - 5 for all fields.
7. After completing all changes, arrow down to select Activate Selection & Exit.
Note:
Note:
Note:
www.wegener.com
Figure 3.4: Unity 550 OSD Carrier Status Screen
Acquisition Mode:TRACKING
RF Feed
Carrier (MHz):
Data Rate (Mbps):04.250
FEC Inner Rate: 3/4
Tag Site:
Program #:
Avg. Eb/No:
Current Eb/No: 10.8 dB
RF Level:
Return To Main Menu
The Carrier must be set before setting the LNB LO frequency.
If you Exit without moving to Activate Selection & Exit, the unit will not retain the
changes.
LNB LO Frequency will change with the RF Input selected by the optional RF
Switch, if that option is installed.
800072-01 Rev. A
CARRIER STATUS
1 (or 2, 3, or 4)
03906.75
1
3
10.7 dB
Good
Unity 550 User's Manual
19
Advertisement
Table of Contents
