Starting The Engine; Stopping The Engine; Operating The Self-Propel Drive And Engaging The Cutting Blades - Toro TurfMaster 22200 Operator's Manual

1
Front cutting height lever
1. Squeeze the lever to disengage it.
g019645
Rear cutting height lever

Starting the Engine

1. Connect the wire to the spark plug (Figure 7).
2. Open the fuel shut-off valve (Figure 17).
Note: When the fuel shut-off valve is open, the lever
is parallel with the fuel line.
g019653
Figure 15
Figure 16
1
g019650
1. Fuel shut-off valve
3. Move the throttle control to the Choke position
(Figure 9).
4. Pull the starter handle lightly until you feel resistance,
then pull it sharply.
5. Move the throttle control lever to the Fast position
when the engine starts (Figure 8).
Note: If the engine fails to start after 3 pulls, repeat
steps 3 through 5.

Stopping the Engine

1. Move the throttle control to the Off position and wait
for all moving parts to stop.
2. Close the fuel shut-off valve and disconnect the wire
from the spark plug if you do not use the machine or
leave it unattended.
Operating the Self-propel
Drive and Engaging the
Cutting Blades
•
To operate the self-propel drive without engaging the
blades, raise the control bar to the handle (Figure 18).
11
1
g019651
Figure 17