JVC SP-THD5S Instructions Manual page 9

If you connect speakers other than those supplied for
the System, use speakers of the same speaker
impedance (SPEAKER IMPEDANCE) indicated on
the rear of the center unit.
DO NOT connect more than one speaker to one
speaker terminal.
TH-D70 only:
– You can install the front speakers on the wall.
When installing them on the wall, do not attach the
stands and base plates.
– When installing the front speakers on the floor,
they are to be assembled before use (see below).
Assembling the front speakers
—TH-D70 only
Front speaker Stand (2)
(SP-THD7F) (2)
Assembled speakers:
You can assemble the front speakers either with or without
stands.
Before assembling:
Take care not to drop any component part while
assembling; otherwise, it may cause an injury or
damage to the floor.
Prepare a Phillips screwdriver (not supplied).
Base plate (2)
or
Do not connect the power cord
until all other connections have
been made.
1
When assembling a speaker with stand:
Speaker
Stand
When assembling a speaker without stand:
Stand
Bottom
cover
Detach the bottom cover and the screws (M4 x 30 mm)
from the stand, then attach them to the bottom of the
speaker.
2
Connect the speaker cord.
(
Stand or speaker
directly
When holding a speaker, always grasp the lower
portion.
Screws M4 x 25 mm
(supplied)
Speaker
5)
Base plate
Screws M5 x 115 mm
(supplied)
6