JVC SP-PWS7 Instructions Manual page 14

Connections
Before connecting the
speaker cords;
Twist and pull the insulation coat
off and remove.
Powered subwoofer
SP-PWS7
Front speakers
SP-THS7F
CAUTION
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
11
Speaker cord (supplied)
• Connect the silver cords to the black (r) terminals.
• Connect the copper cords to the (q) terminals referring to the table below:
FRONT SPEAKERS (LEFT)
FRONT SPEAKERS (RIGHT)
CENTER SPEAKER
SURROUND SPEAKERS (LEFT)
SURROUND SPEAKERS (RIGHT)
4 m 10 m
White
Red
Green
Blue
Gray
Center speaker
SP-THS9C
4 m
Surround speakers
SP-THS7S
(Bottom)
• When installing the satellite speakers on the wall;
Be sure to have them installed on the wall by a qualified personnel.
•
DO NOT install the satellite speakers on the wall by yourself to
avoid unexpected damage from their falling off the wall due to
incorrect installation or weakness in wall structure.
Care must be taken in selecting a location for speaker installation
•
on a wall. Injury to personnel or damage to equipment may result
if the speakers installed interfere with daily activities.
This page is for
Red
Black
Silver
Copper
Route the speaker cord
through the hole on the
bracket.