Operating External Components With The Remote Control; Operating The Tv - JVC SP-PWM303 Instructions Manual

Operating external components with the remote control

The buttons described below are used on pages 12 and
13.
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.

Operating the TV

7 To set the manufacturer's code
You can operate a JVC TV without setting the manufacturer's code.
1
Slide the remote control mode selector
to TV.
2
Press and hold F TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
For a Toshiba TV:
Manufac-
turer
JVC
Akai
Blaupunkt
Remote control
mode selector
Daewoo
Fenner
(play button)
Fisher
Grundig
Hitachi
Inno-Hit
Irradio
Magnavox
Mitsubishi
Number
Miver
buttons
Nokia
5
Release F TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
F TV:
TV VOL +/–:
TV/VIDEO:
CHANNEL +/–:
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:
Press 0, then 7.
Press 2, then 9.
Manufactur-
Code
er
01 Nordmende
02, 05 Okano
03 Orion
10, 31, 32 Panasonic
04, 31, 32 Philips
05 Saba
06 Sanyo
07, 08 Schneider
09 Sharp
02, 05 Sony
10 Telefunken
11, 33 Thomson
03 Toshiba
12, 34
Turns TV on and off.
Adjusts the volume.
Selects the input mode (either TV or
VIDEO).
Changes the channels.
Alternates between the previously selected
channel and the current channel.
Code
13, 14, 18, 26 – 28
09
15
16, 17
10
13, 14, 18, 26 – 28
05
02, 05
20
21 – 25
13, 14, 18, 26 – 28
13, 14, 18,
26 – 28, 30
29
12