Exmark Viking Hydro Operator's Manual page 18

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.16 Install park brake lever:
3.17 Connect wiring harness.
DRIVE LEVER LINKAGE INSTALLATION
Refer to Figure 5. Install the park brake lever to the inside of the park brake
bracket with the lever facing outward using the hardware installed in the park
brake bracket pivot. Install the bolt from the outside with the washer under the
head of the bolt. Install the nyloc nut and tighten. Insert the linkage into the hole
in the park brake lever form the outside and install the hairpin.
PARK BRAKE LEVER INSTALLATION
Route the long unattached portion of the wiring harness up the left handle and
under the console. Connect the connector on the end of the shorter lead to the
key switch. Connect the two flag terminals to the OPC switch in any order.
Continue routing this lead down the right side of the handle and connect the
connector on the end of it to the park brake switch. Fasten the harness to the left
hand side of the handle with two small wire ties, from bolt bag, one at the upper
end of the handle next to the console and one at the very lower end of the handle
where it attaches to the fuel tank support. Repeat for the right side. Using two
small ties from the bolt bag, fasten the harness to the two small holes in the
channel under the console.
www.mymowerparts.com
FIGURE 4
FIGURE 5
- 13 -