Exmark Viking Hydro Operator's Manual page 16

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.6 Install casters to front of deck using appropriate hardware from the bolt bag (eight
3.7 Apply retaining adhesive "Fel-Pro Prolock Retaining I or Retaining II" or "Loctite
3.8 Attach the fuel tank hose to the tank fitting and secure with the clamp provided.
3.9 Position the lower end of the handle assembly on the outside of the upper rear
3.10
3/8 x 3/4" bolts and eight 3/8" whizlock nuts); tightening the lower four bolts first,
then the top four.
RC 609 or 680" on the two threaded studs from the bolt bag and install into the
two left holes underneath fuel tank. Install the fuel tank on top of the fuel tank
support with the studs going through the slots in the support. Install two 5/16 x 3/4
screws with a 5/16 SAE flat washer and 5/16 lock washer into the threaded holes
in the right side of the fuel tank. Do not over-tighten. Place a 5/16" SAE flat
washer, then a spring, over each of the studs and fasten with a 5/16 thin nyloc nut.
Tighten the 5/16 nyloc nut fully than back off a 1/2 turn. This is to allow for normal
fuel expansion and contraction with changes in temperature and fuel levels. Do
not over-tighten.
section of the fuel tank and handle support.
Install four 3/8-16 x 1" bolts (with four spring disk washers against the head of each
bolt) from the outside in. Secure using four 3/8" whizlock nuts on the inside of each
handle support and tighten until the spring disk washers are flat (See Figure 1).
UPPER HANDLE MOUNTING
Attach throttle cable to engine:
Route the throttle cable along the right side of the upper handle, under the fuel
tank support, and position the cable on the left side of the engine.
Attach throttle cable to engine:
a) Position the throttle control lever (located on console) ¼" (.64 cm) from the
upper end of the slot.
b) Attach inner wire of the throttle cable to the top hole in the throttle control lever
as shown in Figure 2.
c) Loosen the clamp, place the cable behind it, and pull on the cable to move the
throttle linkage to the full throttle position. Tighten the cable clamp screw.
KAWASAKI SPEED CONTROL
(THROTTLE CABLE HOOK-UP)
www.mymowerparts.com
FIGURE 1
FIGURE 2
- 11 -