References; Maintenance; Troubleshooting; Handling Discs - JVC GVT0150-008A Instructions Manual

References

Maintenance

7 Handling Discs

• Remove the disc from its case by holding it at
the edge while pressing the center hole lightly.
• Do not touch the shiny surface of the disc or
bend the disc.
• Put the disc back in its case after use to
prevent warping.
• Be careful not to scratch the surface of the
disc when placing it back in its case.
• Avoid exposure to direct sunlight, temperature
extremes and moisture.

Troubleshooting

PROBLEM
Power does not come The power cord and/or system cord is not connected.
on.
The remote control does The batteries are exhausted.
not work.
Sunlight is falling directly on the remote sensor.
No sound. The system cord and/or speaker cord is not connected.
The audio cord is not connected to AUDIO IN (VCR)
and/or DIGITAL IN (DBS) correctly.
An incorrect source has been selected.
The decode mode is not set correctly.
No picture is displayed The video cord is not connected correctly.
on the TV screen.
The disc is not playable.
No picture is displayed The scan mode is set to "NTSC PRG" or "PAL PRG"
on the TV screen, the though the center unit is connected to the TV which
picture is blurred, or the does not support the progressive video input such as a
picture is divided into conventional TV.
two parts.
Video and audio are The disc is scratched or dirty.
distorted.
A VCR is connected between the center unit and the
TV.
The picture does not fit The monitor type is not set correctly.
the TV screen.
Hard to listen to Antennas are disconnected.
broadcast because of
noise.
To clean the disc
Wipe the disc with a soft cloth in a straight line
from center to edge.
• DO NOT use any solvent — such as

7 Cleaning the system

• Stains on the system should be wiped off with a soft cloth. If the
• Since the system may deteriorate in quality, become damaged or
POSSIBLE CAUSE
conventional record cleaner, spray,
thinner or benzine — to clean the disc.
system is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean with a
dry cloth.
get its paint peeled off, be careful about the following.
DO NOT wipe it with a hard cloth.
•
DO NOT wipe it strong.
•
DO NOT wipe it with thinner or benzine.
•
DO NOT apply any volatile substance such as insecticides to it.
•
DO NOT allow any rubber or plastic to remain in contact with
•
it for a long time.
Connect the power cord and system cord correctly.
(A pg. 12)
Replace the batteries. (A pg. 6)
Hide the remote sensor from direct sunlight.
Check the connection.
Connect the cord correctly. (A pg. 12)
Select the correct source. (A pg. 16)
Select the proper decode mode. (A pg. 35)
Connect the cord correctly. (A pg. 11)
Use a playable disc. (A pg. 3)
Change the scan mode to "NTSC" or "PAL".
(A pg. 17)
Replace or clean the disc.
Connect the center unit and TV directly. (A pg. 11)
Set "MONITOR TYPE" properly. (A pg. 37)
Reconnect the antennas correctly and securely.
(A pg. 7)
SOLUTION
42