JVC GVT0150-008A Instructions Manual page 62

Connections
Note that the illustration below is for SP-PWC6.
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
TH-C6: SP-PWC6
TH-C3: SP-PWC3
CAUTION:
SPEAKER IMPEDANCE
4Ω 16Ω
Center speaker
TH-C6: SP-THC6C
TH-C3: SP-THC3C
CAUTION
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
Do not connect the power cord until all other connections have been made.
Front speakers
TH-C6: SP-THC6F
TH-C3: SP-THC3F
Precautions for daily use
• When moving the speakers, do not pull the speaker cords;
• Do not reproduce sounds at so high a volume that they are
(For TH-C6)
• When holding a speaker, always grasp the lower portion.
• Do not lean against the speakers, as the speakers could fall down
Speaker cord
• Connect the black cords to the black (r) terminals.
• Connect the white cords to the (q) terminals
referring to the table below:
FRONT SPEAKERS (LEFT)
FRONT SPEAKERS (RIGHT)
CENTER SPEAKER
SURROUND SPEAKERS (LEFT)
SURROUND SPEAKERS (RIGHT)
Surround speakers
TH-C6:
TH-C3:
otherwise, the speakers may fall over, causing damage or injury.
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
White
Red
Green
Blue
Gray
SP-THC6S
SP-THC3S
10