Installation Sequence - AEG Protect PV Installation Manual

2. Introduction
Protect PV
variant
2
Protect PV
Protect PV
easy
Table 2.1: Differing Features of Protect PV Variants
Product Label
Illustration 2.2: Product Label

2.1.1. Installation Sequence

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
6
User interface Ancillary services
Local Web Server Power Level Adjust-
ment,
Primary Frequency
Control
✓ ✓
✓ ✓ ✓
Read the installation manual. Pay special attention to the section
formation .
Install the inverter according to the section
Mounting the Inverter .
the section
Open the inverter according to the section
Install AC according to the section
Install PV. Remember to use the terminal block to establish parallel connection (if re-
quired), as described in the section
Install Auxiliary input according to the section
Close the inverter according to the section
Turn on AC at the mains switch.
Set language, time, date, installed PV power and country:
- For setup via the integrated Web Server, see the Protect PV User Manual,Web
Server Quick Guide section
- For setup via the display, see the section
this manual.
Turn on PV by turning the PV load switch on.
Verify the installation by comparing with the auto-detection result in the display, as de-
scribed in the section PV Connection .
The inverter is now ready for operation.
8000038781_00_BAL_en / L00410564-01_02
Ride Through Fault Ride Through
Reactive Power
✓ ✓
✓ ✓
The product label on the side of the inverter
shows:
• Inverter type
• Important specifications
• Serial number, see (1), for identifi-
cation by AEG PS
Installation Dimensions and Patterns and
Opening and Closing the Inverter .
AC Grid Connection .
PV Connection . The inverter has auto-detection.
Connection of Peripheral Units .
Opening and Closing the Inverter .
Start-up and Check of Settings in
DC power rat-
ing
10 kW
12.5 kW
15 kW
✓
✓
Important Safety In-