Land Pride 357-344M Operator's Manual page 53

Section 6: Specifications & Capacities
Mower Model No
Overall Length
Tire-to-tire width:
Overall Height Top of folded ROPS
Top of unfolded ROPS
Certified ROPS
Drive Tires
Front Tires
Hour Meter
Fuel Capacities
Steering Type
Twin Lever Steering Controls
Steering Turning Radius
Brake Service
Park Brake Type
Ground Speed
Motor Drive
Wheel Drive
Electrical Operated Logic-Control
Safety Features
Evaporative Emission Control
System on EPA Compliant Mowers
Seat Options
Mainframe Construction
Front Caster Wheels
Front Caster Fork Construction
Deck Thickness
Box-Section Reinforced Front Edge 10 ga. thick
Deck Trim Edges
Deck Housing Depth
Deck Lift
Hand Operated Controls
Indicators
Cup Holder
Cutting Height Adjustments
Mowing Blades
Blade Tip Speed
Blade Drive
Blade Spindles
Deck Suspension
Anti-Scalp Rollers
7/01/14
Table of Contents
General Specifications & Capacities
ZSR54
78 1/4" with hitch plate
48"
50 1/4"
70 1/4"
Standard
5-bolt, 20 x 10 -10 Turf Tread
13 x 5 - 6, Ribbed tread with roller bearings
Standard equipment
12 US GAL
Hydrostatic Twin lever steering provides independent control of each drive wheel.
Speed, forward, reverse, brake, and turns.
True zero degree. Turns with counter-rotating independent drive wheels.
Hydrostatic dynamic braking.
Manual activated over-center lever to pawl over cog wheel.
Forward: 0-7.2 MPH
Reverse: 0-4.5 MPH
Single V-belt with electric clutch and manual take-up idler pulley.
High torque piston type planetary reduction motors
Electric logic-control system governs blade engagement, forward & reverse motion,
engine starting & running, and parking brake functions.
This equipment uses a sealed fuel system which incorporates a non-vented fuel cap.
Evaporative emissions are vented to the engine where they combust during normal
engine operation.
Deluxe cushion seat with arm rests.
Welded steel
Free turning with greasable roller bearings.
5/16" steel.
10 Gauge decks with 11 gauge doubler plate
and 3/16" reinforcement plate connecting spindle housing mounts
Solid 1" x 3/8" steel bar for reinforced trim edge & doubled plated 10 Gauge front edge.
5 3/16" deep, (room for high-capacity mowing)
Foot-operated deck height adjustment with locking pin for setting height.
Ignition switch, throttle lever, control levers, park brake, blade engagement switch,
choke knob, and Fuel Tank Selector Valve.
Engine warning light and hour meter for engine run time.
Two cup holders molded into the left side fuel tank.
Accommodates nearly any cup size.
Height adjustment in 1/4" increments from 1" to 5".
3 Heavy-duty, heat-treated, high-lift steel blades
.25" x 2 1/2" x 18.8"
18,515 FPM
Single B-Section belt drive to all three spindles. Spring loaded take-up idler pulley.
Machined ductile iron housing, 1 3/8" diameter high carbon steel shafts
and greasable ball bearings.
Four point suspension from frame by mechanical linkage with counter balance springs.
4 Anti-scalp rollers to improve flotation in rolling and uneven terrain.
ZSR54, & ZSR60 Accu-Z Razor
ZSR60
.25" x 2 1/2" x 20.9"
18,700 FPM
®
Zero Turn Mowers 357-344M 51