Maintenance Schedule - Land Pride 357-344M Operator's Manual

Section 5: Maintenance & Lubrication
Service at Intervals Indicated
Clean mower, Deck & Engine Cooling System
Verify Safety Start Interlock System
Inspect Unit for loose hardware and damage
Visually Inspect Tires
Check Engine Oil Level
Clean Air Intake Screen
Check Fuel Level
Inspect Fuel System for Leaks
Check Blades - Sharp & Securely Fastened
Check Discharge Chute -
Make sure it is Properly Secured In Place
Grease Blade Spindle Bearings
Change Engine Oil & Filter (1)
Clean Cylinder And Head Fins
Check Battery Connections
Check Tire Pressure With A Gauge
Clean Engine Exterior (3)
Check hydraulic Oil Level
Tighten Lug Nuts On Wheels (2)
Grease Caster Wheel Bearings
Check Ground And Deck Belt Tension (4)
Check Hydraulic system (5)
Change Fuel Filter (3)
Grease Deck Lift Points (8)
Grease Deck Lift Pivot Points (8)
Replace Spark Plugs(3)
Replace Air Cleaner Paper Element (6)
Inspect tethered fuel caps (8)
Change Hydraulic Oil & Filter (7) (8)
NOTES:
1. Initial engine oil and oil filter change is after the first 5 hours of operation. Thereafter, change engine oil and oil filter
every 50 hours of operation. Change every 25 hours when operating the engine under dusty or dirty conditions,
heavy load, high temperatures, and hot weather periods. Refer to Engine Owner's Manual.
2. Torque lug nuts initially and after first 2 hours of operation.
3. Remove cooling shrouds and clean cooling areas. Check oil cooler fins and clean as needed. Refer to Engine
Owner's Manual.
4. Inspect ground and deck belt tensions every 6 months or 100 hours and replace if worn or cracking is noticed.
Otherwise, replace every 200 hours or 2 years whichever comes first.
5. Inspect all hydraulic system components for leaks and repair as necessary. Replace any hoses that are cracked
or damaged.
6. Replace air cleaner filter element if damaged, every 200 hours or every season (whichever comes first). Replace
more frequently when used in dusty conditions.
7. Initial hydraulic oil and filter change is between 25 and 50 hours of operation.
8. X/M = Service per hours indicated in column or monthly (whichever comes first).
X/A = Service per hours indicated in column or annually (whichever comes first).
7/01/14
Table of Contents

Maintenance Schedule

Every Every
25 Hrs 50 Hrs
Daily (After engine has cooled.)
Daily (Before each use)
Daily (Before each use)
Daily (Before each use)
Daily (Before each use & every 4 hours thereafter)
Daily (Before each use & every 4 hours thereafter)
Daily (Before each use)
Daily (Before each use)
Daily (Before each use)
Daily (Before each use)
X
X
X
X
X
X
X
X
ZSR54, & ZSR60 Accu-Z Razor
Every Every
100 Hrs 200 Hrs 500 Hrs
X
X
X
X
X/M
X/M
X
X
®
Zero Turn Mowers 357-344M
Every Refer to
Page
16
30
57
44
45
38
38
42 & 57
48
44
11 & 35
57
36
57
48
40
38
39
49
49
45
X/A 39
X/A 36
31