Land Pride 357-344M Operator's Manual page 36

Section 5: Maintenance & Lubrication
Torque Requirements
Refer to "Torque Values Chart" on page 57 to determine
correct torque values when tightening hardware. See
"Additional Torque Values" at the bottom of the chart
for exceptions to standard torque values.
!
WARNING
Particular attention must be given to tightening the drive
wheel lug nuts, blade spindle bolts, electric clutch bolt and
transaxle mounting bolts and nuts. Not torquing these
components correctly can result in the loss of a wheel, blade
or burnt clutch. Any of the above situations can cause serious
damage to the equipment and/or personal injury.
It is recommended that the following be checked after the
first 2 hours of initial operation and after removal for
repair or replacement. Thereafter, they should be
checked every 50 hours of operation.
•
Blade bolts (See item (#12) in Figure 5-2 on page 32)
•
Electric Clutch bolt (See item (#44) in Figure 5-4 on
page 33)
•
Wheel lug nuts (See item (#13) in Figure 5-16 on
page 41)
•
Transaxle mounting bolts (See item (#12) in
Figure 5-16 on page 41)
Refer to Figure 5-5:
•
Retighten choke and/or throttle cable clamp screws to
35 in-lbs if they work loose or are loosened to make
cable adjustments.
•
See engine owner's manual for all other engine torque
values.
Tighten Choke and Throttle Cable
Clamp Screws to 35 in-lbs.
Choke and Throttle Cable Clamp Screws
Figure 5-5
34 ZSR54, & ZSR60 Accu-Z Razor
Table of Contents
30385
®
Zero Turn Mowers 357-344M
Tires
IMPORTANT: Use only tires recommended by Land
Pride. Solid fill tires are not to be used on Zero Turn
Mowers.
It is important for your safety and the safety of others that
the tires have correct air pressure. Check air pressure in
all four tires before each use. Visually inspect tires for
loss of air throughout each day of operation. See "Tire
Inflation Chart" on page 57 for correct tire pressure.
7/01/14