Table of Contents
Advertisement
Quick Setup
Step 2 – The Remote Control
Before you can operate your remote
control, you first need to install the
batteries (included).
Slide the cover on the back of the
remote down towards the bottom of
the remote control. Insert two batteries
(included) carefully noting the "+" and
"–" markings, placing the "–" end in
the unit first. Slide the cover back into
place.
When you change the batteries, try to complete the task within three minutes. If you
take longer than three minutes, the remote control codes for your VCR, DVD, and/or
cable box/satellite receiver may have to be reset. See pages 26-29.
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television. The top
and bottom buttons will scan forward and back through
the available channels. To move rapidly through the
channels using JVC's Hyperscan feature, press and hold
CH+ or CH –. The channels will zip by at a rate of five
channels per second. The right and left buttons will turn
the volume up or down. These buttons are also marked
with four arrows and are used with JVC's onscreen menu
system. To use the onscreen menus, press the M
button.
14
Getting Started
ENU
Advertisement
Table of Contents
