Getting Started - Panini My Vision X Operator's Manual

Panini My VisionX_07.06 6-10-2006

4. Getting Started

1. Turn on the PC.
2. Start the My Vision X application (see note).
3. Follow the My Vision X application instructions.
4. Load your checks.
Note: An application must be started before you begin to process documents. When the application
starts, the My Vision X turns on which is indicated by the green led in the outer cover.
If it is your job to start the application, refer to the documentation supplied with the application
by the vendor.
Normally, the My Vision X will automatically go on-line when the control application starts, and
goes offline when the control application shuts down. If you want to force the reader to go offline
even when the application is on, press the rear button switch for at least one second; at this point,
the motor will briefly buzz and the green LED will turn off. To put the reader back on-line (only if
the application is still running), press the button switch again for at least one second; the motors
will briefly buzz and the green LED will turn on. Normally, this operation is allowed only when the
My Vision X is idle and will be ignored if the reader is working.
Pressing the button switch when the green LED is off will have no effect.
OPERATOR MANUAL
10:21 Pagina 22
Page 22
Getting Started