Panini My Vision X Operator's Manual page 26

Panini My VisionX_07.06 6-10-2006 10:21 Pagina 26
Batches greater than 30 to 100 checks require the pressure plate
2mm (1/8'')
be pushed back before inserting checks into the feeder.
To prevent misfeeding, do not insert more than 100 documents
into the feeder. Leave at least 2 mm (1/8") between the last
document and the pressure plate in the maximum backwards
position. The leading edges of the documents should be aligned
as described in the previous page.
Fig.21
Document Feeder Options
Depending on the configuration ordered, two feeder types are available:
1. Standard Feeder Option:
• Designed for single document automatic insertion.
• Holds up to 30 documents for automatic batch one hand insertion (without moving the pressure plate).
• Holding up to 100 documents by pushing back the pressure plate before inserting checks into the feeder.
2. Limited Feeder Option: Causes the automatic document feeding operation to stop, followed by a system
warning message, after 30 consecutive documents have been processed, according to the ordered
configuration. The feeder sensor must then be cleared by removing the documents from the feeder and then
repositioning and restarting the application. All other features are the same as the standard feeder.
Note: This option is reset if the feeder is emptied before the 30 document limit is met for the 30 documents
limited feeder.
Page 26
OPERATOR MANUAL Getting Started