Getting Started - Panini My Vision X Operator's Manual

Panini 14-05-2004 9:26

4. Getting Started

1. Turn on the PC
2. Start the application program (see note)
3. Follow the application program instructions
4. Load your checks.
note: Determine what application program will be running during your document
processing session.
An application must be started before you begin to process documents.
If it is your job to start the application, refer to the documentation supplied
with the application by the vendor.
Normally, the My Vision X goes automatically on line when the control application starts, and goes
offline when the control application shuts down. If you want to force the reader to go off line even
when the using application is on, press the rear switch button for at least one second; at this point,
the motor will briefly buzz and the green led will became off. To put the reader again on line (only
if the using application is still running), press again the switch button for at least one second; the
motors will briefly buzz and the green led will became on. Normally, this operation is allowed only
when the My Vision X is idle, and will be ignored if the reader is working.
Acting on the switch button when the green led is off, will have no effect.
Pagina 21
OPERATOR MANUAL
Pag. 21