Aetertek AT-216F Owner's Manual page 7

Quick Start
1
Step 1 Install the antenna onto the transmitter. Make sure the
antenna is securely attached.
2
Step 2 Plug the charger into the DC hole of the master controller
3
Step 3: Screw the metal prongs onto the receiver till securely attached.
AT-216F(2013.01.19) _A1
2013 1 21 11:37:13
4
Step 4 Charge the receivers.
A RED LED light of the receiver is on during charging. When
charging is over, the red LED light will be off with the
BLUE LED light on. Full battery charge takes about 3 hours.
Tips: Recommend to charge the receiver upto 4 hours
for the first 3 times .
Press and hold
on On/Off
button until the
red LED light to
within 1 meter
be solid.
Note:if receiver just
charged, the red LED
light is solid and receiver
is waiting for sync, so no
need to do this
Step 5: Sync the receiver and transmitter.
Unplug the charger, the red Led light is solid and receiver
is waiting for sync ;
Note:if receiver had been turned off and still have power
remained,press and hold on the On/Off button until the red
Led light to be solid, then the receiver is waiting for sync.
As soon as the receiver pairs with the transmitter, the RED
LED light turns off and BLUE LED light flashes every 10 seconds.
R
Wireless Dog/Cat Fence System
AT-216F
5
-05-