General; Installing The Unit Under A Cabinet; Playing A Cd; Setting The Clock - Sony ICF-CD513 Service Manual

AC power cord
Cordon d'alimentation secteur
A
a
b
<
<
Template
Gabarit
c
<
Mounting screw
Vis de fixation
Cord clamp
Attache de cordon
Spacer/Pièce d'écartement
L (Low)
L(Bas)
Dot
Point
SECTION 2

GENERAL

Features
• Built-in CD player with Shuffle/Repeat
function.
• PLL (Phase Locked Loop) Synthesized Tuner
with 15 memory presets for easy one button
tuning.
• Powerful bass with MEGABASS sound system.
• Single alarm function - which can be used as
timer.
• Summer time (daylight saving time)
calculation.
Notes on AM channel step
The AM channel step differs depending on areas.
The channel step of this unit is factory-set to
10 kHz (US, Canadian models)/
9 kHz (AEP model).
Area Channel step
North and South
10 kHz
American countries
Other countries 9 kHz
Installing the Unit
Under a Cabinet
(See Fig. A)
The unit can be installed without the spacer.
1
Mark the position of the 4 holes by
using the supplied template. Use a drill
to make the holes (size 6.5 mm dia.,
9 inch). (See Fig. A- )
/
32
2
When the cabinet door overhangs the
shelf and obstructs the unit, you can
adjust the unit/shelf height.
First set the L mark to the dot which
becomes the lowest position, then you
can adjust the height in 4 steps (H••L)
by turning the spacer counterclockwise.
(See Fig. A- )
3
Install the unit with the supplied
mounting screws. (See Fig. A- )
Caution
• Since the unit is very heavy, be careful when
installing the unit.
• To reduce the risk of fire, do not place any
heating or cooking appliance beneath this
unit.
• Install the unit so that its AC power cord can
be connected directly to a wall outlet. Do not
use a converter or extension cord.
• Be sure that the AC power cord has no slack
when using the unit, since the cord acts as an
FM wire antenna. If the AC power cord has
some slack, wind it up to the cord hook until
the cord has no slack.
• The unit has a built-in ferrite bar antenna for
AM radio reception. Check the condition of
AM reception before fixing in position.
• Install the unit as far as possible from a source
of noise. (for example, refrigerator, microwave
oven, fluorescent lamp, etc.)

Setting the Clock

1
Plug in the clock radio.
The display will flash "AM 12:00" or "0:00".
2
Press CLOCK for a few seconds.
You will hear a beep and the hour will start
to flash in the display.
3
Press TUNE/TRACK/TIME SET + or –
until the correct hour appears in the
display.
– 4 –
This section is extracted from
instruction manual.
4
Press CLOCK once.
The minute will flash.
5
Repeat steps 3 and 4 to set the minute.
After setting the minute, press CLOCK to start
the counting of the seconds, and you will
hear two short beeps.
• To set the current time rapidly, hold down
TUNE/TRACK/TIME SET + or – .
• The clock system varies depending on the
model you own.
12-hour system: "AM 12:00" = midnight
24-hour system: "0:00" = midnight
• In step 5, when you press CLOCK after the
minute setting to activate the clock, the seconds
start counting from zero.
To change the display to the
daylight saving time (summer time)
indication
Press D.S.T./SUMMER T..
" " is displayed and the time indication
changes to summer time.
To deactivate the summer time function, press
D.S.T./SUMMER T. again.
Changing
AM Channel Step
The AM channel step differs depending on areas.
The channel step of this unit is factory-set to
9 kHz or 10 kHz to match the frequency
allocation system of the country as listed.
You can change the channel step.
Area Channel step
AM
North and South
10 kHz
American countries
Other countries 9 kHz
1
Press OFF to turn off the power.
2
While holding down OFF, keep
pressing PRESET 1 for more than 5
seconds. Two short beeps will sound,
and the AM channel step will be
changed.
If you proceed step 2 again, the channel
step changes again.
• When the AM channel step is changed, the
preset stations will be erased.
• When the AM channel step is changed, the FM
channel step is also changed.

Playing a CD

An 8 cm (3-inch) CD can be played without an
adaptor.
1
Press Z OPEN/CLOSE and place a CD
on the disc tray.
2
Press Z OPEN/CLOSE to close the disc
tray.
3
Press CD u.
The player plays all the tracks once.
FM
0.1 MHz
0.05 MHz