Power - Cisco uBR924 Installation Manual

Cable access router
Hide thumbs Also See for uBR924:
Table of Contents

Advertisement

Chapter 2
Preparing for Installation
Table 2-1
Specifications for Operating and Nonoperating Environment
Specification
Temperature, ambient operating
Temperature, ambient nonoperating and storage
Humidity, ambient (noncondensing) operating
Humidity, ambient (noncondensing) nonoperating and storage
Altitude, operating and nonoperating
Vibration, operating
Vibration, nonoperating
For proper airflow, keep the back, sides, and bottom of the cable access router clear of
Caution
obstructions and away from the exhaust of other equipment. To prevent unit overheating,
never install the Cisco uBR924 router in an enclosed rack or room that is not properly
ventilated or air conditioned.

Power

The Cisco uBR924 router does not contain a power switch. After the cable system technician installs,
connects, powers on, and initializes the unit, it is intended to remain connected to the broadband
network when operating normally. Before plugging the unit in, verify that the power source is within
the values given in Table 2-2.
Table 2-2
Cisco uBR924 Cable Access Router Power Specifications
Description
Specification
AC-input voltage
120 to 240 VAC
AC-input current
1.2A
rating
AC-input cable
18 AWG
American (NEMA 5-15P) plug on the power source end; other country-specific cords are available
and supplied as ordered.
Power dissipation
12 to 15W
Frequency
50/60 Hz
1. VAC = volts alternating current.
2. A = ampere.
3. AWG = American Wire Gauge.
4. Hz = hertz.
Note
The same power supply supports both domestic (U.S.) and international operation.
Different power cords are required, however, depending on the country of operation.
OL-0338-01 (3/2000)
1
wide input with power factor correction
2
maximum at 120 VAC and 0.6A maximum at 240 VAC
3
three-wire cable, with a three-lead receptacle on the power supply end, and a North
4
Minimum
32°F (0°C)
–13°F (–25°C)
5%
5%
Sea level
10 to 200 Hz, 0.0005 g (1 oct./min.)
10 to 100 Hz, 0.0065 g (1 oct./min.)
Cisco uBR924 Router Hardware Installation Guide
Site Requirements
Maximum
104°F (40°C)
95°F (70°C)
95%
95%
10,000 ft
(3,050 m)
N/A
N/A
2-5

Advertisement

Table of Contents
loading

Table of Contents