Panasonic KX-FT21BX Service Manual page 163

Personal fax
Table of Contents

Advertisement

Bit No.
Extend field
24
25
2400 bit/s handshaking
26
Uncompressed mode
27
Error correction mode
28
Set to "0"
29
Error limiting mode
Reserved for G4 capability on PSTN
30
31
Unassigned
Extend field
32
33
Validity of bits 17,18
(0)
Bits 17,18 are valid
(1)
Bits 17,18 are invalid
Recording width capability of 1216 picture elements
34
along a scan line length of 151 mm • } 1%
Recording width capability of 864 picture elements
35
along a scan line length of 107 mm • } 1%
Recording width capability of 1728 picture elements
36
along a scan line length of 151 mm • } 1%
Recording width capability of 1728 picture elements
37
along a scan line length of 107 mm • } 1%
Reserved for future recording width capabilities.
38
Reserved for future recording width capabilities.
39
40
Extend field
41
Semi super time / mm
Semi super time / inch
42
43
Super time
inch
44
45
mm
MSC/SF
46
Select polling
47
48
EXT
Note 1 - Standard facsimile units conforming to T.2 must have the following capability : Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have the following capability : Index of cooperation (IOC)=264.
Note 1 - Standard facsimile units conforming to T.4 must have the following capability : Paper length=297 mm.
Signal
Training 1
TCF
(Training Check)
CFR
(Confirmation to Receive)
Training 2
DIS/DTC
Identification Signal Format
A fixed pattern is transmitted to the receiving side at a speed
(2400 to 9600 bps) designated by DCS, and the receiving side
optimizes the automatic equalizer, etc., according to this signal.
Sends 0 continuously for 1.5 seconds at the same speed as the
training signal.
Notifies the sending side that TCF has been properly received.
X0100001
If TCF is not properly received, FTT (Failure To Train)
X0100010 is relayed to the sender. The sender then reduces
the transmission speed by one stage and initiates training once
again.
Used for reconfirming the receiving side like training 1.
Standard setting
1
Extend field
0
2400 bit/s handshaking
0
Uncompressed mode
Error correction mode
0
Frame size 0 = 256 octets
0
Error limiting mode
0
0
Reserved for G4 capability on PSTN
0
Extend field
1
Recording width
Recording width indicated by bits 17,18
0
Recording width indicated by this field bit
information
0
Middle 1216 elements of 1728 picture
elements
0
Middle 864 elements of 1728 picture
elements
0
Invalid
0
Invalid
0
0
1
Extend field
1
0
0
0
1
0
0
0
Function
- 137 -
KX-FT21LA
DCS
1 = 64 octets

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-ft21bx-w

Table of Contents