Replacing The Keyboard And Mouse; Replacing The Adapter; Removing The Stand And Back Cover - Lenovo S40–40 Hardware Maintenance Manual

Replacing the keyboard and mouse

Note: Your keyboard will be connected to a USB connector at either side or at the rear of the computer.
To replace the keyboard:
Step 1. Remove any media (disks, CDs, or memory cards) from the drives, shut down the computer, and
turn off all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Locate the connector for the keyboard. Refer to "Side view of the computer" and "Rear view of
the computer".
Step 4. Disconnect the defective keyboard cable from the computer and connect the new keyboard cable
to the same connector.
Step 5. The mouse can be replaced using the same method.

Replacing the adapter

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Step 1. Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Disconnect the adapter cable from the computer
outlet. 2
Step 3. Connect the new adapter as shown.

Removing the stand and back cover

Attention: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
Note: It may be helpful to place the computer face-down on a soft flat surface for this procedure. Lenovo
recommends that you use a blanket, towel, or other soft cloth to protect the touch screen from scratches
or other damage.
Step 1. Remove any media (disks, CDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
28
Lenovo S40–40Hardware Maintenance Manual
1 , then unplug the power cord from electrical
1 2