Table of Contents
Advertisement
Auto mode : When motion is not detected, output video is being refresh
in configured interval. And when the motion is detected, output video is
switched to real time video.
ON : Always refresh in configured interval.
OFF : Always real time video.
Renewal(sec) : Select an interval between two frame.
When object start moving, The output video possible to cut a little time.
6) ScnChg/Unfoc : Select scene change/unfocus detection On/Off .
Inform that whether scene have been changed or not. Detect breaking or
changing in the watching scene (Spray, Screen Camera, Changing Scene...)
This function is linked with alarm out
In low luminance environment, the accuracy is down of the result.
In very low luminance environment, operation is not be performed.
It is not be performed when moving object is exist.
<System Setup>
1) Cam Info : Camera basic information display
Cam ID/Baud rate/Protocol/Firmware Ver./CCD Type/Lens Type
2) General Setup
System Lock : Configuration Lock.
When system lock is set to "Lock", User must to input 4-character
password to enter OSD menu.
Default password is "0000".
Change PID : Change the administrator's password
Move cursor with OSD Key and Press Enter to input the character.
Comm(RS 485 Communication) : Press the Enter button to access the Comm.
Cam ID : Select the camera ID (001 - 255).
Baud Rate : Select serial communication speed (2400/4800/9600/19200).
Protocol : RS-485 protocol. (COMMAND/FASTRAX/PELCO-D/Pelco-D)
10
Advertisement
Table of Contents
