Spark Arrester - Honda ECM2800 Owner's Manual

SPARK ARRESTER

If the generating set has just been in operation, the muffler will still be very hot. Let it
cool before proceeding with this operation.
CAUTION :
• Poor compliance with the recommended frequency of maintaining the spark arrester can
lead to serious damage to the engine.
ECMT7000
1. Undo the 6 screws maintaining the left side plate and remove the plate
2. Loosen and remove the 4 mm screw [2].
3. Using a screwdriver, remove the spark arrester [1].
4. Use a wire brush to remove carbon deposits from the spark arrester screen and check
that it is not damaged.
5. Reassemble the spark arrester and the screw [2].
[1]
ECM2800
NOTE: we recommend that maintenance of the spark arrester be entrusted to an authorized
Honda dealer.
1. Remove the 5 x 6 mm screws [3] and the muffler
protector [4].
2. Remove:
- the 2 x 8 mm bolts [5],
- the 2 x 8 mm screws [6],
- the muffler [7].
- the gasket [8].
NOTE: Replace the gasket if is damaged.
3. Extract the spark arrester [1].
4. Use a wire brush to remove carbon deposits from
the spark arrester screen and check that it is not
damaged.
5. Make sure that the gasket is correctly installed [8] and reassemble the elements in
reverse order to disassembly. Tighten the screws correctly.
[2]
MAINTENANCE
(see page
[5]
[8]
[1]
[7]
[5]
18).
[1]
[6]
[3]
[4]
21