Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Kaindl SM180
Summary of Contents for Kaindl SM180
- Page 1 OPERATION MANUAL FOR LOOKING THROUGH GRINDING SM180 MACHINE Kaindl-Schleiftechnik REILING GmbH, D-75203 Königsbach-Stein, Remchinger Str. 4, Germany Tel.: +49 7232/4001 -0, Fax.: +49 7232/4001 -30, Internet: www.kaindl.de, E-Mail: info@kaindl.de...
-
Page 2: Table Of Contents
CONTENT EC Declaration of conformity Directed means of use Technical data Duty of taking care by the user Requirement to the operating personnel Moving Set up Transport Environmental conditions for set up Operation Description of the operation parts Change of the grinding wheel Instruction for grinding rest (option) Maintenance Spare parts list... -
Page 3: Ec Declaration Of Conformity
EC DECLARATION OF CONFORMITY The manufacturer: Kaindl-Schleiftechnik Reiling GmbH Remchinger Straße 4 75203 Königsbach-Stein Germany declares that the machine described herein: Type: refers to the security and health requirements EC-Machine instruction (2006/42/EC) of the following EC instructions: EC-Instruction EMV (2004/1 08/EC) -
Page 4: Directed Means Of Use
DIRECTED MEANS OF USE is determined exclusively for hand operated and occasionally grinding of different tools, as drills, cutoff tools, turning tools and hammer drills, etc. For other operations as listed here, the machine is not destined for. That goes for unauthorized use. -
Page 5: Duty Of Taking Care By The User
GENERAL SAFETY ADVISE When working with the through looking grinding machine SM 1 80, always wear your protection glasses DUTY OF TAKING CARE BY USER The looking through grinding machine has been designed and constructed under consideration of an endangering analyses and careful selection of oberved harmonized norms, as well as further technical specifications. -
Page 6: Operation
OPERATION The diamond grinding wheel of the SM 1 80 is also coated on the back side, so that you can grind from below and look from the top through the diamond wheel and see your workpiece. So you have full visible control of your workpiece and can correct the hand held piece if necessary. -
Page 7: Description Of The Operation Parts
DESCRIPTION OF THE OPERATIONS PARTS Optical lens LED lighted (Option) Diamond wheel Switch 0/I Boring holes for screwing on a work table... -
Page 8: Change Of The Grinding Wheel
CHANGE OF THE GRINDING WHEEL threaded pin The threaded pin of grinding wheels must be are tightened in notch of the motor shaft. -
Page 9: Instruction For Grinding Rest (Option)
INSTRUCTION MANUAL FOR LATER BUIDING THE SM 180 GRINDING REST ON THE Unplug the SM 1 80 and ligthed lens from electric current (in case this option is mounted on your machine) Remove the lighted lens (in case this part is mounted) Lay the machine on its side, so that you can see the lower fastening screws (M8 flat-head socket cap screw) Loose all 3 screws and remove the bottom part from the columns... -
Page 10: Maintenance 1
MAINTENANCE Check the circuit cable occasionally. SPARE PARTS LIST 1 0947 Diamond grinding wheel D 1 26 (standard) 1 0948 Diamond grinding wheel D 76 (medium) 1 0949 Diamond grinding wheel D 46 (fine) 1 0946 Grinding wheel support 111 36 Plastic cover for optical lens 11 01 8 Motor SM 1 80 1 450 U/m 240 V /50 Hz...
Need help?
Do you have a question about the SM180 and is the answer not in the manual?
Questions and answers