Table of Contents
Advertisement
ISN-CP1-CM-W50, ISN-CP1-CM-N100 | Installation Instructions | 1.0
1.0 Installation Considerations
The detector senses intruder movement
and notifies an alarm control panel.
Because the detector is only one part of a
complete system, Bosch Security
Systems does not assume responsibility
for damages or other consequences from
an intrusion.
•
Not suitable for outdoor use.
•
Point the detector away from glass or any other
object that changes temperature rapidly.
•
Mount the detector on a solid and vibration-free
surface.
•
Avoid intense electrical or electromagnetic noise.
•
Avoid magnetic material.
•
Avoid corrosive gas and dust.
•
Point away from direct and indirect sunlight.
•
Avoid vapor or high humidity that can cause
condensation.
•
Mount the detector on 2.5 m (8.2 ft) to 5 m (16.4 ft)
ceilings.
•
Install the detector so that intruders cross the
coverage pattern.
•
Do not install the detector where pets are present.
•
Avoid installing the detector where cabinet doors,
curtains, or other objects that can swing or move
are within the coverage pattern.
2
Installation Considerations
2.0 Installation
Do not apply power until after you
connect and inspect all wires.
1. Remove the tamper screw on the base. Refer to
Figure 1.
Figure 1: PIR Detector
2
1
4
3
1 – Detector base
2 – Detector body
2. Push the tamper switch toward the tamper screw to
unlock (Figure 1).
3. Hold the base and turn the detector body
counterclockwise to remove from the base
(Figure 1).
4. Position the base with the printed arrows pointing
in the direction of the desired coverage and mount
the base on the ceiling using the two mounting
screws. Refer to Figure 2 on page 3.
Bosch Security Systems | 8/05 | 4998154997B
3 – Tamper screw
4 – Tamper switch
Advertisement
Table of Contents
