Fault Clearing - IntelliSense SECURIT 800L User Manual

14:0 FAULT CLEARING

SYMPTOM
Zone light on continuous in day
Tone pulsing on exit
Tone continues to pulse after exit
Alarm triggers on exit
Alarm triggers on entry
Tamper light continues to flash
No Mains Light
Panel appears dead (no mains
light)
ZONE No
1
2
3
4
5
6
7
8
Please Note:
IntelliSense are always endeavouring to improve quality and specification of all it's
products and may alter or amend this product and instructions without notice.
Printed & Manufactured in Republic of China by IntelliSense. Document No 5-051-614-00 Rev B
CAUSE
Alarm activated Do a panel reset
Leave protected area and wait for tone to go
Zone in Fault
continuous.
Check for open doors, or a detector is in fault, call
Zone in Fault
your installer
Go quicker to exit or call your installer to extend
Timer ran out
exit time
Timer ran out,
Follow entry procedure, call your installer to
deviated from entry
extend entry time
route.
Tamper fault Call Installer
Mains off, fuse Switch mains on, check other mains appliances,
blown call electricity supplier or installer
battery not taking
Check mains is on. Call installer to check battery.
over
AREA COVERED
7
ACTION