Setting The System; Manual Isolation Of Alarm Zones; Selecting Full/Night Set; Home Set - IntelliSense SECURIT 800L User Manual

1:0 SETTING THE SYSTEM

To arm the system enter your user code. The exit tone from any
extension speakers will sound at a low level, the keypad buzzer will
also sound. Any pulsed tones should return to a continuous tone
once you have left the building and the sensors have cleared. The
control panel arms after the exit timer has run out, at this point the
tone should cease. If for any reason the tone does not go continuous
after all the sensors have cleared, return to the keypad and press the
# key to abort the setting procedure. If the internal sounder activates
after the timer has expired, return to the keypad and enter your user
code and press #. Now refer to fault clearing. (section 14:0)
1:1 Selecting Full Set
Enter user code, no further action is required, leave the premises by
the authorised exit route.
1:2 Selecting Night Set
Enter user code then press * then 0. The zones pre-programmed to
be isolated will start to flash. The extension speaker sounds can be
removed by the installer, if this is the case the extension sounder
may stop as soon as night set is selected. If the installer has
programmed instant night set the system arms as soon as the
selection is made.

1:3 HOME SET

Enter user code then press * then 8. This isolates any zones
programmed for isolation. Please note that this setting method will
allow the isolation of ALL entry routes including zone 1 (if enabled by
the installer). Follow the paragraph 1:0 for guidance regarding exit
tones etc.

2:0. MANUAL ISOLATION OF ALARM ZONES .

There may be occasions when you need to isolate additional zones.
Arm the system as above, then press * then the zone number you
want to isolate. That zone will flash indicating a successful isolation,
if you want more zones isolated press * and another zone. If any
zone is barred from isolation an error tone will be emitted.
Zones that cannot be isolated
•
Fire
•
PA
•
Tamper
•
Zone 1 in Full Set
•
Zone 8
2
SETTING THE
SYSTEM
FULL SET
NIGHT SET
HOME SET
ZONE
ISOLATION