The Remote Control - JVC LT-26WX84 User Manual

Quick Setup
Step 2 – The Remote Control
Before you can operate your remote
control, you first need to install the
batteries (included).
Slide the cover on the back of the
remote down towards the bottom of
the remote control. Insert two batteries
(included) carefully noting the "+" and
"–" markings, placing the "–" end in the
unit first. Slide the cover back into place.
When you change the batteries, try
to complete the task within three minutes. If you take longer than three minutes, the
remote control codes for your VCR, DVD, and/or cable box/satellite receiver may have to
be reset. See pages 23 - 26.
Key Feature Buttons
The four key feature buttons at the center of the remote
can be used for basic operation of the television. The top
and bottom buttons will scan forward and back through the
available channels. To move rapidly through the channels
using JVC's Hyperscan feature, press and hold CH+ or
CH –. The channels will zip by at a rate of five channels per
second. The right and left buttons will turn the volume up or
down. These buttons are also marked with four arrows and
are used with JVC's onscreen menu system. To use the
onscreen menus, press the M
Basic Operation
Turn the television on and off by pressing the P
of the remote. If this is the first time you are turning on the TV, the interactive
plug-in menu appears.
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if
you need to operate a cable box.
• Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to
DVD to control a DVD player. Please see pages 23 to 26 for instructions on
programming your remote control to operate a cable box, VCR or DVD player.
12
button.
ENU
OWER
Getting Started
MUTING
VOL
MENU
VCR CHANNEL
button at the top right corner
C.C.
C.C.
CH
VOL
OK
CH
BACK
C
POWER
T
TV CATV
VCR DVD