Touch Panel Software Installation - Origen ae S16T User Manual

x
1 After opening the setup.exe
file, the install will begin with
the above prompt. Click 'Next'
to continue.
4 The touchscreen controller
should already be connected
if you have correctly
connected all cables inside
your chassis. Click 'OK'.
10

Touch panel software installation

In order to use the touch panel, you must first install the
from either an install CD or downloaded from our website (www.origenae.com
and navigate to support downloads s-series). To begin installation, double
click on the setup.exe file located in the
2 Ensure that 'Install PS/2
interface driver' is not
selected and click
5 If you intend to use spaning
mode with multiple monitors,
please select 'Support Multi-
Monitor Systems'. Click
to continue.
> >
touch panel
'Next' .
'Next'
touch panel software
folder.
3 Select 'None' and click
After completing the install, the
TouchKit software will perform
a 4 point calibration.
6 Change the TouchKit
software install folder if
required and click 'Next'
to continue.
'Next' .