Remote Control - JVC LCT2518-002C-A User Manual

Remote Control

The following pages gives you a brief description of each button's function.
This remote can also control up to four other devices. See pages 51 - 52.
TIMER
POWER
TV STB VCR DVD AUDIO
MODE
V1 V2 V3 V4
1 2 3
4 5 6
7 8 9
RETURN +
0
TV
TUNE
TUNE
18
Allows you to set the TV to turn on and set the TV to turn off
automatically after a set amount of time and channel of your choice.
On Timer / Input / Sleep Timer
Notes:
• If you set the interval of On Timer by pressing the
select channel at Input and press OK.
• After you set On Timer and turn off the TV, power lamp lights.
• You can check the remaining time of On Timer by displaying
this menu again.
• You can set the interval of Sleep Timer by pressing the
buttons.
• 60 seconds before the TV turns off, a message will appear and it
will count the remaining time.
• See page 50, "On Timer using iPod".
Turns the TV on or off.
Switch between "TV / STB / VCR / DVD / AUDIO devices.
See page 51.
Switch between devices connected to Video-1, 2, 3, 4 and 5. For
V4 (Video-4) and V5 (Video-5) you must select the signal input type
fi rst (ie. composite, S-Video, or component). To do so, you need
to press the V4 or V5 button until the correct type is highlighted.
Select "Composite 1" for composite video signal input, "S-Video"
V5
for S-video signal input, or "Component 1" for component video
signal input. Select "Composite 2" for composite video signal input
or "Component 2" for component video signal input. Select PC for
PC signal input.
Change channels. Input remote codes. See page 51.
Lets you decide the input channel and select it. After pressing the
remote 0 - 9 buttons, press TUNE.
Timer
On Timer
Input
Sleep Timer
0 h 0 m
0 - 0
0 min
buttons,